GHHT-195D Industrial Fan Blower
- Impeller diameter: 400-3000mm
- Speed of main shaft: ≤4000rpm
- Pressure range: 364.8-8683Pa
- Flow range: 603.7-154074m3/h
We're here to help: Easy ways to get the answers you need.
Contact: John Sun
Tel: 0086-373-5467003（5467018）
Phone: 0086-13503732601
Fax: 0086-373-5467002
E-mail: htblower@outlook.com
Address: dazhaoying industry zone
Overview
GHHT-195D fan, with larger air flow, moderate pressure, is suitable for conveying clean gas at normal temperature, and is widely used in boiler blowing air, kilns air supply, forced ventilating, forced cooling and heat dissipation, materials drying, papermaking, Clinker cooler system etc.
Features
1. Output higher gas pressure, and provide larger air flow volume, low noise.
2. The motor load can be automatically reduced when airflow resistance is increasing, to prevent motor from destroying.
3. Flexible connection for motor shaft and transmission shaft, no need to tension or change the belt, low maintenance work.
4. Fan system whose impeller‘s diameter below 1400mm, is not needed to match bearing cooling device, can reduce the customer’s cost and maintenance work.
5 Adopting high quality carbon steel manufacturing, or stainless steel and other metal materials according to customers’ requirements.
6. Running test and vibration value test are done for fans after finishing manufacturing, ensuring reliable running
7. In the case of using system base, very easy for installation, no need of professionals direction.
GHHT-195D fan, with larger air flow, moderate pressure, is suitable for conveying clean gas at normal temperature, and is widely used in boiler blowing air, kilns air supply, forced ventilating, forced cooling and heat dissipation, materials drying, papermaking, Clinker cooler system etc.
Features
1. Output higher gas pressure, and provide larger air flow volume, low noise.
2. The motor load can be automatically reduced when airflow resistance is increasing, to prevent motor from destroying.
3. Flexible connection for motor shaft and transmission shaft, no need to tension or change the belt, low maintenance work.
4. Fan system whose impeller‘s diameter below 1400mm, is not needed to match bearing cooling device, can reduce the customer’s cost and maintenance work.
5 Adopting high quality carbon steel manufacturing, or stainless steel and other metal materials according to customers’ requirements.
6. Running test and vibration value test are done for fans after finishing manufacturing, ensuring reliable running
7. In the case of using system base, very easy for installation, no need of professionals direction.
>> INQUIRY
E-mail: htblower@outlook.comTel: 0086-373-5467003（5467018）
